| Next: Bugfixes and changes between
| Up: For the impatient
| Previous: Some examples
| Table of Contents |
Note: the command line switches for raw file input have changed since V3.0 to better match other parameters. See below and subsection 2.1.5.
| switch | parameter | see section |
| -br | bitrate | 2.1.2 |
| -if | input file name | |
| -of | output file name | |
| -iss | number of bits per sample in input file (only needed for raw file input, 16 is default) | 2.1.5 |
| -nc | number of channels in input file (only needed for raw file input, 2 is default) | 2.1.5 |
| -sr | sample rate in input file (only needed for raw file input, 44.1 kHz is default) | 2.1.5 |
| -le | the input file is little-endian (only needed for raw file input) | 2.1.5 |
| -be | the input file is big-endian (only needed for raw file input) | 2.1.5 |
| -l3wav | write Microsoft RIFF/WAVE layer-3 file | 2.1.6 |
| -sti | take input from pipe (stdin) | |
| -sto | write output into a pipe (stdout) | |
| -qual | quality | 2.2.2 |
| -esr | effective sampling rate | 2.2.1 |
| -crc | CRC checksum | 2.2.2 |
| -dm | downmix stereo file to mono | 2.2.2 |
| -v | be verbose | |
| -no-is | do not use intensity stereo | 2.1.3 |